seagate discwizard does not detect drive

Of course, your Seagate drive probably has lots of data on it. If you are using Windows 7 or 8, then you could do that and then Ubuntu would be able to see it too. If this were a brand new 3TB drive, the easy solution would be to re-initialize it as a GPT partition table - unless you are using say Windows XP, which can't support GPT. If you used Disk Wizard to see the whole 3TB drive, it's likely Ubuntu can't see it it then. Looks like your Seagate drive does use an MSDOS partition table. To do that, you either need to use a new partition structure called GPT.or you can use special software to trick Windows into using a larger partition.

You can't have a partition size larger than 2.1TB. If this is truly a 3TB drive, then understand there are limitations to the maximum partition size readable under the old 'MSDOS' partition tables (used for 20+ years in the Windows world, supported by Linux). for example, to detect memory problems or a failing hard drive. The seagate one is a external hard drive.Ī 1TB partition is showing up on /dev/sdc1. Seagate, for example, provides DiscWizard installation software and SeaTools diagnostic. dev/sr0Įrror: /dev/sr0: unrecognised disk sudo blkid Warning: Unable to open /dev/sr0 read-write (Read-only file system). Sector size (logical/physical): 512B/4096B Number Start End Size Type File system Flagsĥ 67.2GB 80.0GB 12.9GB logical linux-swap(v1) Sector size (logical/physical): 512B/512B

Seagate discwizard does not detect drive